|
AK-47.net:
Romanian Model MK-11 & C.U.R.-2 |
|
|
Romanian Model MK-11 & C.U.R.-2
|
Characteristics |
| Caliber,
mm |
5.45x39
Russian |
| Length,
in: |
34
in. |
Weight
Capacity |
6.9lbs
All AK-74 Mags and Drums |
| Action |
Semi-Auto |
| Barrel
length |
16.25
inches |
| Operation |
Gas
operated, rotating bolt |
| Effective
Range |
600
Meters |
| Rifling |
1-10
twist, Right hand 6 grove |
| Price |
$400-$600 |
| |
|
The Romanian MK-11
Rifle is a post 89 ban sporterized AK. The rifle fires
the 5.45x39 Russian cartridge and is the only AK-74 variant
imported in to the country. The rifle comes PACKED with
grease, a 5 round magazine, cleaning kit and manual. The
rifle accepts all high cap AK-74 mags including the East
German bakelite mags. The rifle also comes with a muzzle
nut to protect the front of the barrel. However don't
let this fool you in to thinking you have a threaded barrel,
you don't. The muzzle nut is has been pressed on under
high pressure. |
|
If you wish to
remove it take your gun to a gunsmith he must use a high speed
cutting tool to remove it. The Romanian MK-11 also has
the original bayonet lug still attached, however the
side rails that hold the bayonet have been ground down to
satisfy Clinton. The MK-11 comes with a pre-installed
side scope rail which utilizes the quick detach feature.
Some Romanian AK-74 rifles were imported in to the
country with AK-74 muzzle breaks tack-welded to the barrel for
legality, I believe that only the C.U.R models had this
feature. There were approximately 8000-10000
imported before the most recent wave of ones have come in that
only accept 10 round mags. Most Romanian AK74s were made
in one of three factories: the Cugir Factory, the Sadu Factory
(current Romanian military small arms provider according to an
internet news article) and by RomTechnika. We believe that
only rifles produced by Cugir were imported into the
U.S. by three companies, D.I.G. of Va.Beach, VA.,
Intrac, of Knoxville TN, we are uncertin of the third.
The Romanian AK-74 also has some fairly common design flaws.
First the front sight base appears to be off center and
slightly to the right. Second at the point in which the
rear sight support meets the receiver I can see right in to
the receiver. There are two rectangular holes that allow
me to see right through the rifle. Other than that the
only other complaint I have is the large grip on the stock,
this can be corrected by either shaving down the wood or
replacing it with a U.S. parts kit. Please send any
information you may have on this rifle to webmaster@ak-47.net.
AK-47.net Rating: 
|
| AIM Surplus |
WebSite:
Email: n/a
Phone: n/a |
Item
Number: n/a
Price: n/a
When ordering, mention AK-47.net |
|
|
The entire content of The Guns Network LLC, included
but not limited to text, photographs, images,
graphics, videos, audios, screen savers, trademarks,
logos and service marks, is owned and are copyright ©
1995 – 2007 All rights reserved. The Guns Network LLC
is protected by copyright, trademark and other
intellectual property laws. No portions of The Guns
Network LLC may be reproduced without the express
written consent of The Guns Network LLC. The Opinions,
Views and Comments expressed by the members of this
forum and website are their own and do not necessarily
state or reflect those of The Guns Network LLC or any
of it's agents. The Guns Network LLC does not
guarantee the accuracy, integrity or quality of these
messages and opinions, and does not perform an
independent investigation to verify their truth or
accuracy. All posted messages are the sole
responsibility of the person from which such post
originated. If any posted message breaks our rules and
guidelines, we have the right to delete such postings
at any time. In no event will The Guns Network LLC be
liable to you for any damages of any kind, including
but not limited to, compensatory damages, lost
profits, lost data, deleted postings or any form of
special, incidental, indirect, consequential or
punitive damages of any kind whether based on breach
of contract or warranty, tort (including negligence),
product liability or otherwise, even if The Guns
Network LLC is informed in advance of the possibility
of such damages.
|
